Chevrolet Monza Recalls

THESE VEHICLES MAY NOT COMPLY WITH CMVSS 1101 - EMISSION DEVICES.

THE RIGHT OR LEFT REAR SEAT LAP BELT OUTER AUTOMATIC LOCKING RETRACTOR MAY NOT FULLY LOCK WHEN THE OCCUPANT BUCKLES UP THE SEAT BELT. THIS MAY RESULT IN SMALL SIZE OCCUPANTS NOT BE

On certain Monza Spyder vehicles equipped with V6 engines and dual exhaust. The reduced exhaust back pressure with dual exhaust tail pipes causes nitrogen oxide emissions to increa

THE ENGINE OIL PRESSURE SWITCH MAY HAVE A RANDOM INTERNAL ELECTRICAL SHORT WHICH COULD RESULT IN THE ENGINE STARTING BY ITSELF WHEN THE IGNITION SWITCH IS TURNED TO THE "ON" POSITI

MOVEMENT OF THE FRONT SUSPENSION MAY DEFORM THE LEFT ENGINE MOUNT SUPPORT STRUCTURE AND ALLOW THE ENGINE MOUNT BRACKET TO CONTACT THE STEERING PITMAN ARM OR STEERING LINKAGE. THIS

VEHICLES WITH V6 ENGINES. THE FRONT WHEEL BEARING GREASE MAY NOT BE ADEQUATELY RETAINED IN THE FRONT WHEEL BEARINGS. INSUFFICIENT GREASE CAN CAUSE WHEEL BEARING FAILURE AND DAMAGE

VEHICLES EQUIPPED WITH POWER STEERING. THE STEERING INTERMEDIATE SHAFT COUPLING POT JOINT MAY HAVE BEEN MACHINED OVERSIZE IN THE SERRATION AREA WHERE THE JOINT ATTACHES TO THE STEE

On cetain Monza 2+2, Monza Town Coupe, Skyhawk and Sunbird vehicles, the front disc brake shoes may not be held in the proper position by the brake shoe reaction area of the front

On certain Astre, Monza 2+2, Sunbird and Vega vehicles equipped with the l-4 engine and 2 barrel carburetor. Vehicles were assembled with an incorrect carburetor.

On certain Monza 2+2, Skyhawk and Starfire vehicles, the strength of the conventional spare tire hold down "J" bolt may be inadequate in the event of a severe frontal collision. If