Dodge Neon Recalls

On certain vehicles, the rear suspension crossmember may be missing spot welds. This may result in structural cracks in the body, and reduced crash protection in the event of a rea

THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. THE SOLID STATE FAN RELAY COULD FAIL BECAUSE OF HEAT RELATED ELECTRICAL OVER STRESS CAUSING THE FAN(S) TO STO

THE STEERING COLUMN COUPLER MAY BECOME DISCONNECTED WHEN THE VEHICLE EXPERIENCES A SEVERE IMPACT TO THE UNDERCARRIAGE. THIS WOULD RESULT IN LOSS OF STEERING CONTROL. CORRECTION: ST

THE CIRCUIT DESIGN IN THE AIR BAG ELECTRONIC CONTROL MODULE MAY ALLOW THE POTENTIAL FOR INADVERTENT AIR BAG DEPLOYMENT UPON VEHICLE IGNITION SHUT DOWN. CORRECTION: THE AIR BAG ELEC

THE FUEL AND REAR BRAKE TUBES MAY EXPERIENCE ACCELERATED CORROSION BETWEEN THE TUBES AND A RUBBER ISOLATOR. FAILURE OF THESE TUBES COULD RESULT IN FUEL LEAKAGE AND/OR DIMINISHED BR

On certain vehicles, the brake master cylinder may leak brake fluid due to a damaged double lip rear piston seal. Brake fluid leakage may result in diminished effectiveness of one

AN ENGINE WIRING HARNESS MAY SHORT DUE TO CONTACT WITH THE EXHAUST GAS RECIRCULATION (EGR) TUBE. SHORTING OF THE HARNESS MAY CAUSE VARIOUS ELECTRICAL MALFUNCTIONS, INCLUDING ENGINE

VEHICLES MAY EXPERIENCE AN ENGINE DIE OUT DUE TO MOISTURE IN THE POWERTRAIN CONTROL MODULE (PCM) CAUSED BY INADEQUATE POTTING MATERIAL SEALING. ALSO, THE REAR BRAKE LINES MAY BE OU

VEHICLES MAY HAVE BEEN BUILT WITH A REAR ABS BRAKE MASTER CYLINDER SEAL THAT MAY ALLOW AIR INGESTION INTO THE CYLINDER AND CAUSE SPONGY BRAKE FEEL OR PARTIAL BRAKE SYSTEM LOSS. COR