Forest River Impression Recalls

On a small number of RV trailers, the insulation on the wires for the shore power inlet may not have been removed properly. As a result, the wires could be exposed and cause electr

On certain RV trailers, the wrong suspension parts may have been installed on the axle(s). As a result, the trailer could be overloaded and cause a wheel to detach and/or and a lea

On certain RV trailers, the receiver for the removable step on the side of the trailer may not have been attached properly. As a result, the receiver could detach from the bracket

Issue: On certain RV trailers, certain 12 V wiring may not have proper circuit protection. Additionally, the wiring for the solar controller may be too small. As a result, the wiri

On one fifth wheel RV trailer, the emergency exit window was not installed. As a result, you may not be able to escape from the trailer in an emergency if the entry door is blocked

On certain RV trailers and motorhomes, the fabric for the patio awning may not be properly attached. As a result, the awning could detach and fall from the vehicle.

On certain RV trailers and motorhomes, the quick disconnect fittings for the propane (LP) gas system may be defective. As a result, the fittings could crack and leak propane.

On certain RV trailers, the rear identification lamps may not have been positioned correctly. Canadian regulations have specific requirements for the position of trailer lamps.

On certain travel trailers, the axles may not have enough grease on the inner hub bearings. This could cause the bearings to overheat and fail, potentially resulting in wheel locku