Four Winds Windsport Recalls

On certain motorhomes, an incorrect electrical connection at the transfer switch buss bar could cause the transfer switch to overheat and melt. This could result in a vehicle fire

On certain motorhomes equipped with Lippert Components Inc. electric entry steps, an internal bolt on the steps that attaches the fan gear assembly to the steps could fracture. Thi

On certain motorhomes, an incorrect electrical connection at the transfer switch buss bar could cause the transfer switch to overheat and melt. This could result in a vehicle fire

On certain motorhomes, an incorrect electrical connection at the transfer switch buss bar could cause the transfer switch to overheat and melt. This could result in a vehicle fire

On certain motorhomes, the cable for the transmission range indicator "PRND321" on the instrument cluster may be damaged by a sharp edge on the shift lever arm. If the indicator ca

Certain refrigerators used in Recreational Vehicles (RVs) contain either a sensing algorithm or a thermal switch to interrupt power when it detects high temperatures that could lea

On certain motorhomes, the brake calipers may stick in the applied position. This can result in abnormal heat generation at the wheel end which, if undetected, could eventually lea

On certain vehicles, the castle nut that retains the steering drag link to the pitman arm may have been improperly torqued during assembly. The improper torque may have damaged the

Certain motorhomes may have an improperly routed and/or supported propane gas line to the kitchen slide-out room. As a result, the gas line could rupture causing a propane gas leak

On certain vehicles equipped with Workhorse Custom Chassis, an incorrect steering intermediate shaft may have been installed. The incorrect part has a finer pitch spline. Use of th

On certain motorhomes equipped with Workhorse Custom Chassis, the engine fuel rail pulse damper retainer clip may fracture, resulting in inadequate retention of the damper. If the

On certain motorhomes equipped with Workhorse Custom Chassis, the engine fuel rail pulse damper retainer clip may fracture, resulting in inadequate retention of the damper. If the

On certain motorhomes, incorrect software programmed into the instrument panel cluster may not allow certain driver warnings, required by CMVSS 101 and 105, to be displayed. As a r

On certain vehicles, a spacer plate located on the trailer hitch may not fit flush with the rear extension of the hitch. The improper fit of the spacer plate causes the fasteners t

On certain motorhomes, the front brake caliper slides could bind, which may lead to performance issues such as overheated brake components and potentially fire, burn or smoke incid

On certain motorhomes, the braided fuel supply line on the chassis could chafe against the steel floor structure, causing the fuel line to rupture. Fuel leakage, in the presence of

Certain motorhomes equipped with the slide out option were manufactured with a 20/15 amp breaker instead of a 15/15 amp breaker. The use of the incorrect breaker size may cause the

On certain vehicles, the driver and passenger three-point shoulder harness seat belts may not have been installed properly. The seat pedestal brace which holds the seat belt harnes

On certain recreational vehicles equipped with a Samsung microwave oven, an electrical short can occur in the microwave oven's membrane panel keypad causing the oven to activate wi

On certain vehicles, the brake system warning indicator will not illuminate when the ignition is in the start position or when the brake fluid is low. Correction: The brake warning

On certain motorhomes, the independent movement between the chassis frame and the motorhome body may cause the LP gas copper tubing or the manifold pipe to split or crack causing a