Gmc Jimmy Recalls

On certain vehicles, the multifunction switch may develop an open circuit condition with the bottom contact of the hazard switch, causing the stop lamps and the hazard lamps to bec

On certain vehicles, sustained loads of sufficient magnitude and duration on the seat belt in severe crashes could fully deploy the buckle energy-absorbing loop, introducing a tota

Certain vehicles (not involved in recall 98-150), may experience a windshield wiper failure due to cracked solder joints on the controller circuit board. If this were to occur in a

On certain vehicles, a short in the electric outside rearview mirror switch could develop. If this were to occur, it could result in an inoperative switch, heat damage to the drive

Certain sport utility vehicles. The multifunction switch could develop an open circuit condition with the bottom connector in the hazard switch carrier that results in the stop lam

Certain vehicles: Light duty trucks. passenger vehicles and sport utility vehicles. Certain vehicles do not comply with the requirements of C.M.V.S.S. NO. 118, "POWER-OPERATED WIND

Certain vehicles do not comply with the requirements of CMVSS 201- Occupant Protection. Vehicles have a console cover/armrest cam latch that can release at less than the 10 g verti

Certain vehicles may have incorrect payload information on the vehicle certification label. The payload shown on the label is greater than the maximum validated payload. If the veh

Certain vehicles do not comply with the requirements of C.M.V.S.S. 209 - Seat Belt Assemblies. Vehicles may have seat belt assemblies that will not withstand the force requirements

Certain four wheel drive vehicles may experience increased stopping distances during ABS stops while in the two-wheel drive mode. A switch can erroneously signal the ABS system tha

Certain vehicles may exhibit a fatigue fracture of the rear axle, right-hand brake pipe. Should the pipe crack a slow brake fluid leak would result causing a soft pedal and an even

On certain vehicles, the driver's and/or passenger's front outboard seat-belt webbing could separate during a frontal impact having at least the same dynamics as a 48 kph frontal b

CERTAIN VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 301 - FUEL SYSTEM INTEGRITY. IN CERTAIN TYPES OF VEHICLE CRASHES, THE PROPSHAFT MAY PENETRATE THE FUEL TANK, RESULTING IN A FUEL LEA

NOTE: 4-DOOR VEHICLES ONLY. THESE VEHICLES MAY EXHIBIT A CONDITION WHEREBY A REAR SEAT BELT BUCKLE RELEASE BUTTON CAN STICK IN THE UNLATCHED (DOWN) POSITION UNDER CERTAIN CONDITION

CERTAIN 4WD VEHICLES COULD HAVE EITHER OR BOTH UPPER BALL JOINTS UNDERTORQUED. THIS CAN RESULT IN IMPROPER SEATING OF THE TAPERED BALL JOINT STUD IN THE TAPERED HOLE OF THE STEERIN

THESE VEHICLES MAY HAVE THE BRAKE PEDAL PIVOT BOLT STARTED IN THE WELD NUT BUT NOT TORQUED ("FINGER LOOSE"). WITH THE BOLT "FINGER LOOSE", IT IS POSSIBLE FOR THE BOLT TO DISENGAGE

NOTE: 4-DOOR VEHICLES LOCATED IN BRITISH COLUMBIA, ALBERTA, ONTARIO AND QUEBEC. THESE VEHICLES MAY HAVE TRAILER HITCH ATTACHING BOLTS TIGHTENED BELOW THE SPECIFIED TORQUE. THIS COU

NOTE: 2 DOOR VEHICLES ONLY. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 209 - SEAT BELT ASSEMBLIES. REAR SEAT BELT ASSEMBLY MAY NOT RELEASE WEBBING FROM THE RETRACTED POSITION. C

NOTE: 4-DOOR VEHICLES. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 301 - FUEL SYSTEM INTEGRITY. - FUEL TANK SENDER SEAL MAY BE OUT OF POSITION. CORRECTION: VEHICLES WILL BE INSPEC

On certain vehicles, excessive enlargement of a pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate possibly leading to loss of brake fluid in the r

UNDER CERTAIN OPERATING CONDITIONS, WHERE MODERATE BRAKE STOPS ARE MADE, THE INERTIA LOCK MECHANISM MAY NOT FUNCTION ALLOWING THE SEAT BACK TO FOLD FORWARD, AND THE SEAT TO MOVE FO