Indian Motorcycle Chieftain Recalls

On certain motorcycles, the rear suspension push rod could fail. If this happens, the rear suspension could collapse and pinch the main wiring harness, damage the coolant reservoir

On certain motorcycles, the wiring for the crankshaft position sensor may have been routed incorrectly. As a result, it could become damaged by contact with the exhaust head pipe.

On certain motorcycles, a poor electrical connection at the Vehicle Control Module (VCM) could lead to an intermittent or total loss of forward lighting.

On certain vehicles, a problem with a 10-A circuit breaker could result in intermittent electrical issues. This could result in a loss of power to the engine or the lights.

On certain motorcycles, the gear position switch may malfunction. This can cause the wrong gear to be indicated on the motorcycle's display. As a result, the display could indicate

On certain motorcycles, the rear tail/running lights are too bright. This might make it difficult for a following driver to tell when the brake lights turn on. Canadian regulations

On certain motorcycles, a poor electrical connection at the Vehicle Control Module (VCM) could lead to an intermittent or total loss of forward lighting.

On certain motorcycles, electrical components within the right hand switch cube may develop corrosion over time. This could result in an electrical short in the cube that may lead

Certain motorcycles equipped with halogen headlights may not comply with the requirements of Canada Motor Vehicle Safety Standard (CVMSS) 108 - Lighting System and Retroreflective

On certain motorcycles, the fuel rail could shift positions and could contact other components and chafe, causing a fuel leak. Leaking fuel, in the presence of an ignition source,

On certain motorcycles, the engine may misfire and cause unburned fuel to be routed into the exhaust system. This could result in excessive exhaust heat that may pose a fire hazard

On certain motorcycles, the primary cup seal in the rear master cylinder could tear. If this were to occur, brake fluid pressure to the rear caliper would be reduced, and the perfo