Isuzu Npr-Hd Recalls

On certain trucks, the chassis and cab wiring harnesses may not have been routed properly. As result, the wiring could become damaged by contact with nearby components and cause a

On certain trucks, the seal on the fuse holders for the ignition coil packs may be too small. As a result, water could leak into the fuses and cause them to corrode or fail. If thi

On certain trucks, the U-bolts that attach the rear axle to the suspension may not be properly tightened. As a result, the axle could slide back and separate from the propeller sha

On certain trucks, the lug nuts on the rear-outer wheels were not properly tightened during assembly. This could cause the nuts to loosen or fall off, and could result in a wheel s

On certain vehicles, the odometer display may show the units of distance as miles instead of kilometers. The actual number display is in kilometers.

On certain vehicles equipped with diesel engines, the brake switch retaining tab may not have been fully secured into the steel brake pedal assembly bracket, and could allow for th

On certain vehicles, the left rear wheel bearing hub locking bolts may not have been properly torqued during assembly. This could cause the bolts to loosen and break, which could a

On certain vehicles, a burr could impede contact between the transmission mounting bracket and the chassis cross member. This could cause the fasteners to shear or break, allowing

On certain vehicles with gasoline powered engines, the accelerator pedal could move laterally, allowing the accelerator pedal bracket to be hung up on the stopper bolt on the floor

Certain vehicles with gasoline powered engines may be equipped with a fuel tank that could prematurely corrode and leak. A fuel leak in the presence of an ignition source could inc

Certain trucks equipped with an automatic transmission could experience a sudden transmission failure. This would result in a loss of vehicle propulsion which, in conjunction with

On certain vehicles equipped with an oil pan heater, over time, dust, dirt and moisture may collect at the contact point between the oil pan heater cord and the extension cord. As