Jayco Alante Motorhome Recalls

On certain motorhomes, the Smart Data Link Connector (SDLC) module may have been damaged by moisture during vehicle assembly. As a result, the module, connector and wiring harness

On a small number of motorhomes, the bolts that attach the rear brake calipers may not be properly tightened. As a result, the bolts could loosen over time and a caliper could cont

On certain motorhomes, the nuts that attach the rear stabilizer bar bracket(s) could loosen and the attachment bolts and bracket could break. If this happens, the bolts and bracket

On certain motorhomes, the main chassis wiring harness may be located too close to the exhaust manifold. As a result, the harness could melt. If this happens, the engine could stal

On certain motorhomes equipped with a Dometic propane gas stove, there could be an odour of propane gas after a short period of use. If a user attempts to tighten the bolt for the

Issue: On certain motorhomes, the motor that controls the power bed lift system could fail. If this happens, the bed could fall suddenly. Safety Risk: A bed that falls suddenly cou

Issue: On certain motorhomes built on a Ford chassis, the insulation for the engine cover may be missing. As a result, some surfaces inside the motorhome could get hot while the en

On certain motorhomes, a heat shield was not installed over the exhaust system. This could cause the hydraulic lines for the levelling system to overheat and melt. If this happens,

On certain motorhomes, the dash blower motor does not have proper fuse protection. As a result, an electrical overload or short circuit could cause the wiring to overheat.

On certain motorhomes, the hydraulic hoses for the levelling system may not be properly routed and could be damaged. A hydraulic fluid leak onto a hot exhaust surface could increas

Certain motorhomes may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 104 – Windshield Wiping and Washing System. When travelling at higher speeds

Certain motorhomes may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 104 - Windshield Wiping and Washing System. The wiper system could fail as i

On certain motorhomes, the wiring for the entrance step may have been installed incorrectly and it is possible that the step could retract on its own. If the step were to retract,

On certain motorhomes, the driver and front passenger seat base nuts could loosen over time due to the seat(s) swivelling. This could cause the seat(s) to detach from the seat base