Jeep Commander Recalls

On certain vehicles, the ignition key may not fully return to the RUN position from the START position once the key is released after starting the vehicle. This could affect variou

On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the driver unintentionally

On certain vehicles equipped with a full-time four-wheel drive system, the transfer case controller could fail. This could cause the transfer case to shift into or through the neut

On certain vehicles that were not equipped with a factory sunroof, the supplemental side airbag inflatable curtain may not position properly during inflation. The side curtain airb

Certain vehicles equipped with automatic transmission may have been built with a Wireless Ignition Node (WIN) module exhibiting a binding condition of the solenoid latch. This may

Certain vehicles may have been built with an improperly manufactured rear track bar. This could result in noise and reduced vehicle stability, which may cause a crash causing prope

On certain vehicles, the brake booster input rod may have been installed without the retaining clip, or in some cases, with an improperly formed retaining clip. Should the input ro

On certain vehicles, the driver airbag squib wires on the steering column control module (SCCM) may be reversed. As a result, the driver airbag may not deploy as intended which can

On certain vehicles equipped with a 4.7L engine, the Powertrain Control Module (PCM) contains software that may allow the engine to stall under certain operating conditions. Engine

On certain vehicles, the front control module may have been manufactured incorrectly. This could cause the engine to stall while driving, or not to start, and/or cause the windshie

On certain vehicles, software programmed into the Antilock Brake System (ABS) electronic control module may allow a momentary delay in braking when coasting up a hill during certai

On certain vehicles, the front brake calipers were improperly manufactured and could break under certain operating conditions. This could increase the vehicle's stopping distance a

On certain vehicles, the Anti-lock Brake System (ABS) control module software may cause the rear brakes to lock-up during certain braking conditions. This could result in a loss of

On certain vehicles, the edge of the seat belt retractor bracket on the third-row seat may contact the seat belt webbing during certain operating conditions. As a result, the seat