Jeep Grand Wagoneer Recalls

On certain vehicles, the left and right rear quarter glass trims may not have been secured properly. As a result, the trim(s) could loosen and separate from the vehicle.

On certain vehicles, the window trims on the front doors may not have been secured properly. As a result, the trim(s) could loosen and separate from the vehicle.

Issue: On certain vehicles, a software problem could cause the rearview camera image not to appear on the display. Canadian regulations require the rearview image to display when t

On certain vehicles, a software problem could cause the rearview camera image not to appear on the display. Canadian regulations require the rearview image to display when the tran

On certain vehicles, the steering column control module may not have been manufactured properly. As a result, the driver-front airbag may not inflate in a crash.

Issue: On certain vehicles, the third-row seat belt buckles may not be accessible or may have been damaged during production. As a result, a passenger may not be able to buckle the

Issue: On certain vehicles, a software problem could cause the rearview camera image to not appear on the display screen. Canadian regulations require the rearview image to display

Issue: On certain vehicles, the upper B-pillar trim may not be installed correctly. As a result, the side curtain airbags may not inflate properly in a crash. Safety Risk: A side c

On certain vehicles, the occupant restraint controller (ORC) may not work properly due to a software error. This could cause the airbag warning light to not turn on when there is a

NOTE: VEHICLES EQUIPPED WITH 5.9 LITRE ENGINES. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. CATALYST BISCUIT DETERIORATION RESULTS IN EXHAUST EMISSIONS

THE LIFTGATE MAY BECOME DIFFICULT TO UNLATCH OR MAY NOT LATCH WHEN SHUT DUE TO AN INTERNAL RUBBER BUMPER INTERFERING WITH THE MOVEMENT OF THE LATCH PAWL. IF THE LIFTGATE DOES NOT L

THESE VEHICLES MAY CONTAIN FRONT SUSPENSION CAM BOLTS WHICH MAY FAIL DUE TO ASSEMBLY MISALIGNMENT WHICH COUULD CAUSE THE BOLT TO BEND AND POSSIBLY CRACK DURING INSTALLATION. FAILUR

THE RETAINER CLIP THAT SECURES THE MASTER CYLINDER INPUT ROD TO THE BRAKE PEDAL MAY NOT BE PROPERLY INSTALLED, POSSIBLY PREVENTING FULL CLIP ENGAGEMENT. THIS COULD RESULT IN THE IN

ON VEHICLES EQUIPPED WITH AN ELECTRICALLY OPERATED TAILGATE WINDOW,THE KEY OPERATED WINDOW MIGHT CONTINUE TO CLOSE IF THE KEY DOES NOT AUTOMATICALLY RETURN TO THE OFF POSITION WHEN

CRUISE CONTROL MAY NOT HOLD SET POINT. WHEN SET BUTTON IS PRESSED, VEHICLE SPEED WILL HUNT ABOVE AND BELOW SET POINT. INCONSISTENT VEHICLE SPEED COULD RESULT IN A VEHICLE CRASH. CO

THESE VEHICLES MAY HAVE BEEN BUILT WITH CONTAMINATED BRAKE FLUID.

THE LEFT AND RIGHT FRONT INNER WHEEL BEARINGS MAY HAVE INSUFFICIENT LUBRICANT. THIS CONDITION CAN CAUSE THE AFFECTED BEARINGS TO SEIZE AT LOW MILEAGE AND COULD RESULT IN LOSS OF VE