Kenworth T270 Recalls

On certain trucks, the steering gear may not have been assembled correctly. As a result, the steering gear could break and cause a loss of steering.

On certain trucks, the fasteners that attach the steer arm to the steering knuckle may fail. If this happens, the steer arm could separate from the steering knuckle and cause a los

Issue: On certain trucks, the hoses between the fuel pump and remote fuel filter may be defective and could leak. Note: This recall only affects trucks equipped with a Cummins 2021

On certain trucks, the warning light for the tractor anti-lock brake system (ABS) may not turn on if the system loses power. If this happens, the driver will not get warning that t

On certain trucks, an air supply hose for the brake system could separate due to loose compression fittings. This could result in a loss of air to the brakes. This would affect bra

On certain vehicles equipped with an Eaton automated manual transmission and electronic clutch actuator (ECA), the clutch may have been manufactured improperly and could fail. If t

On certain vehicles, the outer spindle nut on the front wheel hub assembly may have been incorrectly installed. This could lead to a bearing failure, which could result in the sepa

On certain vehicles, the castellated nut and cotter pin on the steer axle may not have been tightened to specification. This could cause the tie rod to become loose in the steer ax

On certain vehicles, water could migrate into wiper motor head and could lead to internal corrosion. This internal corrosion could form a conductive salt bridge which could result

On certain vehicles, brake chamber diaphragm(s) may not be properly seated. This could lead to brake drag, causing brake overheating or unintended spring brake application. These i

On certain vehicles equipped with Cummins ISB and ISL engines, the fuel filter shell and nut plate could separate, causing a fuel leak and also causing the engine to stall. Stallin

On certain vehicles, the seat belts may not comply with Canada Motor Vehicle Safety Standard 209 - Seat Belt Assemblies. Due to a defect in manufacturing, the seat belt buckle may

The stop/turn/tail lights used on certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 108 - Lighting System and Retroreflective De

On certain trucks, an internal defect in the ignition switch can cause the starter to engage when the key is partially inserted. This would allow the engine to start unexpectedly,

On certain trucks equipped with Bendix ATR-6 Antilock Traction Relay valves, in extremely cold conditions (at or below -18 degrees Celsius), internal ATR valve leakage can occur. T

On certain vehicles, the slack adjuster housings may have been manufactured incorrectly, which could allow the housings to fracture and fail. As a result, the wheel brake to which

On certain trucks, the air governor was assembled with a blank plug instead of a breather. Without the breather, the air governor may not be able to detect the loss of pressure in

The emergency vehicle applications that are subject of this recall are designed with a dash-mounted switch that enables the vehicle operator to inhibit the aftertreatment diesel pa

On certain vehicles, the anchor plate tie bar for the 73mm calipers was inadvertently omitted during vehicle assembly. This could cause a loss or reduction of brake force applied t

On certain trucks, a harness support bracket mounted on the underside of the cab may come into contact with the fuel line at the top of the fuel splitter valve (on units with a due