Kenworth T440 Recalls

On certain trucks, the reservoir tank for the air brake system is too small. In certain situations, this could cause reduced braking. Canadian regulations require enough air reserv

On certain trucks, the steering gear may not have been assembled correctly. As a result, the steering gear could break and cause a loss of steering.

On certain trucks, the fasteners that attach the steer arm to the steering knuckle may fail. If this happens, the steer arm could separate from the steering knuckle and cause a los

Issue: On certain trucks, the hoses between the fuel pump and remote fuel filter may be defective and could leak. Note: This recall only affects trucks equipped with a Cummins 2021

On certain vehicles equipped with an Eaton automated manual transmission and electronic clutch actuator (ECA), the clutch may have been manufactured improperly and could fail. If t

On certain vehicles, the castellated nut and cotter pin on the steer axle may not have been tightened to specification. This could cause the tie rod to become loose in the steer ax

Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 121 - Air Brake Systems. The two service brake connections of the SR-7 spring brake va

Certain vehicles equipped with HID headlamps may not comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. A Dayti

On certain vehicles equipped with Cummins Westport ISL-G engines, excessive engine crankcase pressure could cause the vent tube assembly elbow to detach from the breather. This cou

On certain vehicles, water could migrate into wiper motor head and could lead to internal corrosion. This internal corrosion could form a conductive salt bridge which could result

On certain vehicles, brake chamber diaphragm(s) may not be properly seated. This could lead to brake drag, causing brake overheating or unintended spring brake application. These i

On certain vehicles equipped with Cummins ISB and ISL engines, the fuel filter shell and nut plate could separate, causing a fuel leak and also causing the engine to stall. Stallin

On certain vehicles equipped with Cummins ISL G or ISX12 G engines, incorrect engine ECU programming could cause the exhaust system temperature to become elevated during cold weath

On certain vehicles, the seat belts may not comply with Canada Motor Vehicle Safety Standard 209 - Seat Belt Assemblies. Due to a defect in manufacturing, the seat belt buckle may

The stop/turn/tail lights used on certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 108 - Lighting System and Retroreflective De

On certain trucks, the alternator wiring may come into contact with the exhaust manifold, which could result in a fire causing injury and/or damage to property. Correction: Dealers

On certain trucks, the slip-resistant surface of the cab access step is not aligned with the cab door opening. This could allow the user to slip and fall from the vehicle, which ma

On certain trucks equipped with Bendix ATR-6 Antilock Traction Relay valves, in extremely cold conditions (at or below -18 degrees Celsius), internal ATR valve leakage can occur. T

Certain vehicles fail to meet the service brake release requirements of Canada Motor Vehicle Safety Standard 121 - Air Brake Systems. The quick release air valve (in the gladhand c

On certain vehicles, the slack adjuster housings may have been manufactured incorrectly, which could allow the housings to fracture and fail. As a result, the wheel brake to which

On certain vehicles, one of the harness spade terminal connections to the chassis load center may become completely unseated. An unseated connection may result in a power loss to a