Lexus Rx 350 Recalls

Under certain conditions, a software problem could cause the rearview camera image not to display when the transmission is shifted into reverse.

Issue: Under certain conditions, a software problem could cause the rearview camera image to freeze or not to display. If this happens, the rearview image may not display when the

Issue: On certain vehicles, the second-row center seat belt may have been damaged during production. As a result, the seat belt could break in a crash. If this happens, the seat be

On certain vehicles, the head restraints on the front seats may not have been manufactured properly. As a result, the head restraints could move or detach from the seats in a crash

Issue: On certain vehicles, a sensor for the occupant classification system (OCS) may not have been manufactured properly. As a result, the sensor could short circuit and cause the

This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable

On certain vehicles, the low-pressure fuel pump could fail. If this happens, then engine may run rough or may not start and the check engine light may turn on. This could also resu

On certain vehicles, the low-pressure fuel pump could fail. If this happens, then engine may run rough or may not start and the check engine light may turn on. This could also resu

Issue: On certain vehicles, the low-pressure fuel pump could fail. If this happens, then engine may run rough or may not start and the check engine light may turn on. This could al

On certain vehicles, an oil passage in the rotor of the vacuum pump may not have been machined properly and could result in oil not being distributed throughout the pump. This coul

On certain vehicles, the airbag system pressure sensors and/or acceleration sensors used to detect vehicle impact may contain manufacturing defects. As a result, the airbag warning

On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in

Certain vehicles may not comply with Canada Motor Vehicle Safety Standard 302 - Flammability. Some of the materials used in the construction of the seat upholstery may not meet the

Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 126 - Electronic Stability Control Systems. Some brake actuator pumps may have

On certain vehicles, the driver’s knee airbag inflator may have been assembled with an improperly located weld seam. If this condition is present, the weld could be insufficient or

On certain vehicles, the end cap on the right-hand side fuel delivery pipe, located in the engine compartment, could have been improperly welded at time of manufacture. This could

On certain vehicles, a manufacturing defect could affect the functioning of the electric brake actuator, illuminating various warning lights in the instrument panel of the vehicle

On certain vehicles, the accelerator pedal may become stuck in the wide open position due to an unsecured or incompatible driver’s floor mat. A fully depressed accelerator pedal ma

On certain vehicles equipped with Vehicle Dynamics Integrated Management (VDIM), the calibration for the hydraulic control valves was incorrectly written and programmed into the br

On certain vehicles, if the forward retention clip used to secure the floor carpet cover, which is located in front of the center console, is not installed properly, the cover may