Mazda Mazda6 Recalls

Issue: On certain vehicles, the fuel pump could fail. If this happens, the engine may run rough or may not start and the check engine light may turn on. This could also result in a

On certain vehicles, a software error in the Powertrain Control Module (PCM) could cause the valve clearance adjuster not to work properly. This could result in internal engine dam

The front cross-member may rust due to a manufacturing defect. This could affect handling and cause reduced steering control.

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the

On certain vehicles, the passenger frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture,

On certain vehicles registered and operated in areas of heavy road salt usage during winter months (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundl

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the

On certain vehicles, there may be excessive weld spatter on the front passenger seat frame due to a manufacturing issue. Over time, the occupant classification sensor wire harness

On certain vehicles equipped with hand-operated parking brakes, the rear brake caliper protective boot on the parking brake system may not perform as intended, causing the parking

On certain vehicles, a defect in the supplemental restraint system (SRS) controller could result in airbags and seatbelt pretensioners failing to deploy in a crash where deployment

Note: This recall is superseded by recall 2018578 (Mazda Recall 2618F). Please see recall 2018578 for more information. On certain vehicles, the passenger frontal airbag inflator c

On certain vehicles, the driver frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, wh

Mazda Canada is conducting a voluntary Safety Improvement Campaign concerning the driver's airbag inflator on certain vehicles equipped with Takata airbags. Mazda will replace the

Note: For Mazda6 models, this recall is superseded by recall 2018578 (Mazda Recall 2618F). Please see recall 2018578 for more information. For RX-8 models, this recall is supersede

On certain vehicles, a defect in the fuel tank venting system could allow the fuel tank to be overfilled, causing fuel to enter the charcoal canister and possibly resulting in a fu

On certain vehicles equipped with the regenerative braking system, a fault could cause the charging system to malfunction, which would display the charging system malfunction warni

On certain vehicles equipped with the 2.5L engine, a particular type of spider may weave a web in the evaporative canister vent line which may cause a restriction in the line. If t

On certain vehicles, door latch screws could loosen over time, causing the door(s) to fail to latch when closed and illuminating the door ajar warning light. If the vehicle is driv

Note: This recall is superseded by recall 2018578 (Mazda Recall 2618F). Please see recall 2018578 for more information. On certain vehicles, the passenger (frontal) airbag inflator

On certain vehicles equipped with the 2.5L engine, a particular type of spider may weave a web in the evaporative canister vent line which may cause a restriction in the line. If t

On certain vehicles, the outer door handle may bind, thereby preventing the door from latching. This could allow the door to swing open while the vehicle is in motion. Correction:

On certain vehicles, the locking mechanism of the rear seat belt retractor may have been incorrectly assembled. As a result, the rear seat belts may not lock if the vehicle is invo

On certain vehicles, the fuel sender unit may have been improperly installed in the fuel tank. This will produce an inadequate seal, and if the vehicles continue to operate with th

On certain vehicles, the float in the fluid level sensor inside the brake reservoir could be forced off of the guide rail during the filling of the master cylinder. Should this occ