Mercedes-Benz Sl Class Recalls

Issue: On certain vehicles, the recall repairs completed by a Mercedes-Benz dealer during recall 8297011 (Transport Canada recall no. 2024-105) may not have been done correctly. As

On certain vehicles, the 80 A fuse may not have been manufactured properly. As a result, the fuse could overheat and fail. If this happens, there could be a sudden loss of power to

On certain vehicles, the fuel delivery module could fail. If this happens, the engine may run rough or may not start. This could also result in a sudden loss of engine power while

Issue: On certain vehicles, the starter wiring harness may have been routed incorrectly. As a result, the wiring could be damaged by contact with the driveshaft. If this happens, t

On certain vehicles, the fuel delivery module could fail. If this happens, the engine may run rough or may not start. This could also result in a sudden loss of engine power while

On certain vehicles equipped with the emergency calling (eCall) system, the SIM card for the communications module could disable itself. If this happens, the eCall system would not

On certain vehicles equipped with the emergency calling (eCall) system, the communications module may temporarily lose power during a crash. If this happens, the wrong vehicle loca

Issue: On certain vehicles, a software problem could cause the rearview camera image not to appear on the central display. Canadian regulations require the rearview image to displa

Issue: On certain vehicles, a faulty part could cause one of the mounts for rear axle carrier to detach. If this happens, the driver may notice a loud knocking sound from the rear

On certain vehicles, the passenger-front airbag may not meet manufacturer specifications. This could cause the airbag not to inflate properly in a crash.

On certain vehicles, the electric power steering control unit may have been manufactured with improperly soldered contacts. If the pins of the control unit were to lose complete co

On certain vehicles, the front passenger airbag diffusor may not have been properly secured to the diffusor frame at time of assembly. This could affect airbag deployment, and pote

On certain vehicles, the front passenger seat Occupant Classification System may malfunction and deactivate the front passenger airbag while a person is seated in the front passeng

Certain vehicles equipped with Active Body Control (ABC) the sensors on the front struts may not operate within tolerances. As such, the sensor signal may not be accurately transmi

On certain vehicles, the Sensotronic Brake Control (SBC) unit may contain a pump piston which is out of permissible tolerances. Also, vibrations within the electrical connector may

The electronic monitoring system of the Sensotronic Brake Control (SBC) is designed to monitor the pressure gradient within the high pressure line of the brake system. If an unacce

On certain SL320, SL500 and SL600 vehicles, corrosion of the electrical ignition filament of the supplementary restraint system (SRS) gas generator module may occur if the vehicle

On certain vehicles, if a headlamp wiper arm is forced down into a groove below the headlamp due to misadjustment by a workshop or dur to physical force, it can become jammed into