Mercury Lynx Recalls

THE FORWARD OUTBOARD PEDESTAL OF THE SEAT TRACK OF THE DRIVER'S SEAT MAY BE SUSCEPTIBLE TO FATIGUE FRACTURE. FRACTURE OF THIS PEDESTAL WOULD PERMIT A LIMITED DEGREE OF ROCKING MOTI

THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. THE CENTRAL FUEL INJECTOR (CFI) MAY OPERATE RICH DURING CERTAIN OPERATING CONDITIONS. CORRECTION: IMPROVED C

ON 1984 MODELS, EXTERNAL CRACKS MAY DEVELOP IN THE ENGINE CYLINDER HEADS, WHICH MAY RESULT IN AN OIL LEAK ONTO THE EXHAUST MANIFOLD. ON 1985 MODELS, THE ENGINE ROCKER COVER GASKET

THE FORWARD SCREW WHICH PROVIDES PART OF THE ATTACHMENT BETWEEN THE DRIVER`S SEAT BACK ASSEMBLY AND THE SEAT CUSHION FRAME COULD FRACTURE AND PERMIT THE DRIVER'S SEAT BACK TO PIVOT

ON VEHICLES WITH EFI OR CFI, THE SPRING-LOCK FUEL LINE COUPLING USED TO CONNECT THE FUEL SUPPLY AND RETURN LINES TO THE EFI FUEL RAILS OR TO THE CFI THROTTLE BODIES AS WELL AS OTHE

THE REAR SEAT BELT RETRACTORS MAY ALLOW TWISTED WEBBING TO ENTER THE RETRACTOR HOUSING. TWISTED WEBBING MAY WEDGE BETWEEN THE RETRACTOR SPOOL AND HOUSING PRODUCING A JAMMED RETRACT

VEHICLES WITH 1.9L ENGINE AND AIR CONDITIONING. A PIN LOCATED ON THE THROTTLE LEVER WHICH ACTUATES THE AIR-CONDITIONER SHUT-OFF SWITCH MAY BE SUBJECT TO MISALIGNMENT SUCH THAT THE

VEHICLES MAY HAVE INADEQUATE CLEARANCE BETWEEN THE RIGHT FRONT BRAKE TUBES AND A BRACKET MOUNTED TO THE ENGINE. UNDER CERTAIN CONDITIONS THE BRACKET COULD CONTACT THE METAL BRAKE T

ON VEHICLES WITH OPTIONAL FRONT SEAT RECLINERS, THE UPPER SHOULDER SCREW THAT ATTACHES THE DRIVER'S SEAT BACK FRAME TO THE RECLINER MECHANISM MAY BE SUSCEPTIBLE TO FATIGUE FRACTURE

THE FRONT SLEEVE BUSHINGS OF THE COOLING FAN MOTORS ARE SUSCEPTIBLE TO EXCESSIVE CORROSION IN AREAS OF HIGH ROAD SALT USE. THIS MAY INCREASE THE ROTATIONAL FRICTION OF THE FAN MOTO

WHEN SEVERELY LOADED BY A FRONTAL IMPACT, THE SEAT BELT WEBBING MAY CONTACT THE LEADING EDGE OF THE FRONT SEAT-BACK STELL REINFORCEMENT PLATES. THIS MAY CAUSE THE SEAT BELT WEBBING

THESE VEHICLES DO NOT COMPLY WITH CMVSS 1103 - EXHAUST EMISSIONS. VEHICLES AFFECTED: 1.6 L ENGINE AND ATX TRANSMISSIONS

THIS VEHICLE MAY NOT COMPLY WITH CMVSS 1103 - EXHAUST EMISSIONS. NOTE: THIS VEHICLE IS LOCATED IN THE PROVINCE OF NOVA SCOTIA.

THE UPPER TORSO RESTRAINT D-RING WHICH ATTACHES THE SHOULDER BELT TO THE B PILLAR, UNDER CERTAIN TEST CONDITIONS, SEPARATED FROM ITS ANCHORAGE, AND MAY NOT COMPLY WITH CMVSS 210 -

SOME OF THE VEHICLES (EQUIPPED WITH 1.6 LITRE ENGINES, CALIBRATION 3-03B-R10) MAY HAVE BEEN BUILT AND SHIPPED WITH EXHAUST AIR SUPPLY AIR CONTROL VALVE HOSES REVERSED. EMISSION LEV

THESE VEHICLES MAY NOT COMPLY WITH CMVSS 1103 - EXHAUST EMISSIONS.

TWO DOOR MODELS. FATIGUE CRACKS MAY OCCUR IN THE DOOR LOCK PILLARS AT THE FRONT DOOR LATCH STRIKER REINFORCEMENT ATTACHMENT LOCATIONS. THE FATIGUE CRACKS MAY PROPOGATE TO THE EXTEN

STATION WAGONS. THESE VEHICLES MAY NOT COMPLY WITH CMVSS 210 - BELT AHCHORAGES.

VEHICLES WITH OPTIONAL AIR CONDITIONING. THE AIR CONDITIONER BLOWER MOTOR THERMAL LIMITER MAY NOT OPERATE AS INTENDED WHEN THERE IS A MOTOR BLOCKAGE OR MALFUNCTION. THUS, IF THE BL

VEHICLES MAY HAVE AN ELECTRICALLY UNGROUNDED FUEL INLET. AS A RESULT THEY MAY BE SUBJECT TO A STATIC CHARGE ACCUMULATION AT THE FUEL FILLER OPENING, IF A VEHICLE IS REFUELED FROM A

VEHICLES EQUIPPED WITH POWER BRAKES. POWER BRAKE BOOSTERS MAY HAVE BEWEN IMPROPERLY ASSEMBLED BY SUPPLIER. MIS-INDEXING OF REAR SHELL OF SOME BOOSTERS RELATIVE TO THE FRONT SHELL M

VEHICLES WITH AUTOMATIC SPEED CONTROL. FUEL MAY MIGRATE THROUGH THE SPEED CONTROL VACUUM LINES INTO THE SPEED CONTROL SERVO ASSEMBLY THIS COULD CAUSE THE VACUUM O-RING TO SHRINK AL

METAL FASTENERS USED TO SECURE THE CARPETING TO THE FLOOR PAN MAY HAVE BEEN MILOCATED AND MAY HAVE PENETRATED THE TOP OF THE FUEL TANK. THIS CONDITION MAY ALLOW FUEL LEAKAGE.

VEHICLES MAY HAVE INADEQUATE TORQUE ON THE RIGHT AND LEFT REAR BRAKE BACKING PLATE ATTACHMENT BOLTS TO WITHSTAND THE LOADS EXPERIENCED DURING RRUCK SHIPMENT. SHOULD THE BACKING PLA

VEHICLES EQUIPPED WITH AIR CONDITIONING MAY HAVE THE MAIN ENGINE COMPARTMENT WIRE ASSEMBLY INCORRECTLY ROUTED ABOVE THE AIR CONDITIONING SUCTION HOSE SUCH THAT THE WIRE ASSEMBLY CO