Micro Bird Mbii School Bus Recalls

On certain school buses, the anchor screw caps for the wheelchair restraint system may not have been installed properly. As a result, the tie-downs may not lock correctly and could

Issue: On certain school buses, the power cable for the air conditioning control board may not have been tightened properly. As a result, the cable could loosen and overheat. Note:

On certain school buses, the rod end fitting that attaches the door panels to the door opening gear could fail. If this happens, the door panel(s) could become loose and open unexp

Issue: On certain school buses, the exterior handle for the rear emergency door may not be strong enough. As a result, the handle could break and cause the emergency door not to be

On certain school buses, the roof hatch (emergency exit) may not have a French label. Canadian regulations require labels to be in English and French.

Issue: On certain school buses, the seat-level rub rails on the outside of the bus may not have been attached correctly. As a result, there may be reduced protection in a side impa

On certain school buses, the power cable for the air conditioning control board may have a loose connection. As a result, the circuit board could overheat and melt.

On certain school buses, an unused wiring harness located in the B-pillar area could become damaged. If this happens, the wires could short circuit.

On certain school buses, the service door may not be adjusted correctly. As a result, the door panels may get stuck when the emergency release handle is used, or may not open when

On certain school buses, the passenger shoulder belt anchorage plate(s) may not be attached correctly. In the event of a crash, the belt anchorage plate may become partially or tot

Certain school buses may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 222 - School Bus Passenger Seating and Crash Protection. The thickness of the foam in the k

On certain school buses built on a Ford chassis, wheel alignment adjustment bolts may not have been sufficiently tightened at time of assembly. This could allow suspension and stee

On certain school buses equipped with a Ricon wheelchair lift, the lift platform sides may crack, which could cause the lift to lean against the vehicle door(s) and potentially fal

Certain buses may not comply with Canada Motor Vehicle Safety Standard 220 - Rollover Protection. Roof crush testing, required by the standard, was not correctly performed by the m

On certain school buses equipped with a Ricon wheelchair lift, the lift platform sides may crack, which could cause the lift to lean against the vehicle door(s) and potentially fal

On certain school buses, the wiring harness for the flashing lights (used while passengers are boarding or leaving the vehicle) may be undersized and could fail. Failure of the lig

On certain vehicles equipped with a Ricon F9 series cassette wheelchair lift, an improperly manufactured switch in the wheelchair lift restraint buckle may allow operation of the l