Mitsubishi Lancer Recalls

Issue: On certain vehicles, road salt can corrode the front cross-member (subframe). As a result, a lower control arm could eventually detach from the cross-member. This could caus

On certain vehicles, water may drain from the windshield cowl area onto the front wiper link ball joint. Over time, this could result in corrosion and/or wear to the joint, which c

On certain vehicles, the passenger frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture,

On certain vehicles, the sunroof may not have been bonded properly and could separate from the vehicle. This could pose a risk to other road users, increasing the risk of injury an

On certain vehicles, the flange of the drive belt automatic tensioner may crack over time due to repetitive high load operations and stress concentration. This could cause the driv

On certain vehicles, defective electrical relays may have been installed in the power distribution center. This could cause various electrical circuits to fail, potentially resulti

On certain vehicles, the passenger frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture,

On certain vehicles operated in areas of heavy road salt usage, a mixture of snow, water and road-salt solution may infiltrate between the front impact sensor and the bracket that

On certain vehicles equipped with a continuously variable transmission (CVT), the range switch could momentarily experience a loss of signal. If this occurs, the driver may experie

On certain vehicles, road salt can corrode the front crossmember assembly, which may ultimately lead to separation of the control arm at the mounting point. This would allow the wh

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the

On certain vehicles, the passenger frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture,

On certain vehicles, the blower motor may have been incorrectly manufactured. This could result in a premature failure of the blower motor which could affect the defroster performa

On certain vehicles, the ECU which controls the head lights, tail lights and windshield wipers may have been improperly manufactured. This could cause the voltage in the ECU to bec

On certain vehicles, the drive belt material may cause abnormal pulley wear. If the vehicle is driven under this condition, the drive belt may become damaged from the worn pulley a

Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. An incorrectly manufactured turn si

On certain vehicles operated in areas of heavy road salt usage, the front impact sensors may corrode between the sensor bushing and sensor bracket. Over time, the corrosion may cau

On certain vehicles, the brake booster check valve may stick closed when the engine is shut off. When the vehicle is re-started and put into motion, under certain driving condition