Newmar Essex Diesel Pusher Motorhome Recalls

On certain vehicles, the steering column slip shaft may have inadequate spline engagement. This could lead to wear and potentially result in the steering shaft becoming disconnecte

On certain motorhomes, the refrigerator heated water line circuit breaker may have the wrong size amperage rating and the 12 volt thermostat and 12 volt heated water line could als

On certain motorhomes, the rear jack mounting bracket may have been attached too close to the rear suspension air bag. This could damage the suspension air bag over time, potential

On certain motorhomes built on a Spartan Chassis, steering link fastener nuts may have been insufficiently tightened at time of assembly. If these nuts were to loosen completely, t

On certain vehicles equipped with a four-in-one air gauge, the air brake system pressure gauge may display an inaccurate pressure reading. This could cause the service brake air pr

Certain refrigerators used in Recreational Vehicles (RVs) contain either a sensing algorithm or a thermal switch to interrupt power when it detects high temperatures that could lea

On certain motorhomes, the V-Bus Field-Effect Transistor (FET) control boards, part of the energy management system, may suffer from an unrecognized excessive current situation. Th

On certain motorhomes and fifth wheel trailers, the plug-in remote control receiver used to operate the Dimplex electric fireplace or electric stove may overheat. This could result

Certain motorhomes may contain a defective crimp connection in the auxiliary battery cable assembly. A defective connection may result in an inadequate electrical connection or dis

On certain vehicles, a quick release valve (QRV) contains a rubber diaphragm that may delaminate and cause leakage, a restriction, or blockage of the airflow, thereby affecting pre

On certain motorhomes, chassis fasteners could fracture, resulting in poor vehicle handling, loss of steering and/or reduced level of suspension performance which could result in a

On certain vehicles, the steering gear may have been assembled with an incorrect recirculating ball spacer which could allow the recirculating balls to escape from the ball circuit