Nissan Armada Recalls

Issue: On certain vehicles, a software problem could cause infotainment system display to remain blank when the vehicle is started. As a result, when the transmission is shifted in

On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash.

On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash.

On certain vehicles, the fuel pump could fail. If this happens, the engine could stall while driving.

Issue: On certain vehicles, the reflex reflector in the left headlamp assembly may not have been manufactured correctly. As a result, the reflector may reflect slightly less light

Issue: On certain vehicles, the driver-front airbag inflator could be defective. This could cause the airbag to deploy with more force than normal. It could also cause the inflator

Issue: On certain vehicles, the rear view camera system does not return to the default setting when the transmission is shifted to reverse. This could cause a reduction in rear vis

Certain vehicles may not comply with Canada Motor Vehicle Safety Standard 209 - Seat Belt Assemblies. Incorrect driver and passenger front seat belt buckles may have been installed

On certain vehicles, the brake master cylinder could malfunction, causing a reduction in braking performance which could increase stopping distances and potentially result in a cra

Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 210.1 - User-ready Tether Anchorages for Restraint Systems. Specifically, the pictogra

Certain vehicles fail to conform to Canada Motor Vehicle Safety Standard 110 - Tire Selection and Rims. Specifically, the compliance label does not indicate the wheel rim size, as

On certain vehicles the Intelligent Power Distribution Module (IPDM) assembly contains an Engine Control Module (ECM) relay that has a diode for electrical current noise reduction.

On certain vehicles, the lower control link assembly collars (forming the inboard attachment point to the chassis) may not have been manufactured correctly. If the collar weld fail

On certain four-wheel drive vehicles, the joint portion of the front driveshaft may contain small cracks. These cracks may eventually lead to a failure, resulting in separation of

On certain vehicles, the brake pedal pivot pin end was not properly manufactured. As a result, the pin may not remain in place, causing the brake pedal to partially disengage from

On certain vehicles, the material used on fuel level sending unit contacts can wear and contaminate the sender. This causes the instrument panel fuel gauge to display that the vehi

Certain 2005-2006 model year vehicles may have been assembled with an incorrectly manufactured air conditioning condenser fan motor, which could allow excessive water intrusion and

On certain vehicles, the third row left outboard seat belt shoulder harness anchor may fail to comply with strength requirements of CMVSS 210. As a result, the seat belt may not pr