Nissan Quest Recalls

On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash.

On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash.

On certain vehicles, when driving at low speeds or idling on a downward grade, with ¼ tank or less of fuel, an error in the fuel pump control program may restrict fuel supply to th

On certain vehicles, the brake pedal pivot pin end was not properly manufactured. As a result, the pin may not remain in place, causing the brake pedal to partially disengage from

Certain vehicles may have been assembled with faulty seat track assemblies. Specifically, the driver's inboard, and the passenger's outboard seat tracks, may have undersized slots

On certain vehicles, the transverse link attachment to the front suspension may not have received adequate tightening torque during vehicle assembly process. A loose transverse lin

On certain vehicles, the 3rd-row curtain side-impact airbag on the driver's side may have been installed slightly out of position during vehicle assembly. This could cause the airb

On certain vehicles, a third row seat bracket striker may become detached from its mounting bracket due to a broken weld at the point of attachment. Striker separation may increase

On certain vehicles, the seat adjustment mechanism contains exposed moving metal components located at the rear inside edge of the second row seat. An operators finger may be pinch

On certain vehicles equipped with a power sliding door(s), at an ambient temperature below approximately 4 degrees Celsius, the actuator for the power sliding door(s) may bind. In

On vehicles equipped with the automatic airbag suppression feature option, the front passenger seat is equipped with a seat cushion bladder and sensors used for occupant detection.

On certain vehicles, cracks could develop in the fuel tank vent hose. If (1) the fuel tank is overfilled, not allowing excess fuel in the vent hose to flow back into the tank, (2)

Certain vehicles do not comply with the requirements of CMVSS 209 - Seat Belt Assemblies. The seat belt assemblies may not withstand the force requirements of the standard. In a cr

On certain vehicles, the retaining bolts for the steering rack mounting brackets may not have been torqued to the proper specification. This could eventually cause the steering rac

On certain vehicles, the seat belt assemblies may not withstand the force requirements of the standard. In a crash, if the belt buckle fails, there is an increased risk of injury t

On certain vehicles, the plastic socket for the stop/tail light bulb in the rear combination lamps may not have been molded properly resulting in loss of dimensional stability over

On certain vehicles, the easy entry and exit latch system on the second row right hand side captain's chair may have inadequate lubrication. In some cases the actuator spring may d

THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 118 - POWER-OPERATED WINDOWS, POWER-OPERATED PARTITIONS AND POWER-OPERATED ROOF PANELS. THE ACCESSORY DELAY FEATURE, WHICH ALLOWS THE P

THESE VEHICLES MAY HAVE BEEN MANUFACTURED WITH DEFECTIVE BATTERIES. THE BATTERIES MAY HAVE NEGATIVE TERMINALS THAT COULD FRACTURE CAUSING ACID LEAKAGE AND RELATED CORROSION DAMAGE

A REAR LAMP ON THESE VEHICLES MAY NOT ILLUMINATE BECAUSE THE METAL CAN IN THE LAMP SOCKET MOVES OR SEPARATES FROM THE PLASTIC SOCKET HOUSING. THIS CAN RESULT IN THE STOP/TAIL COMBI

NOTE: ALL VEHICLES INVOLVED IN THIS RECALL WERE CORRECTED PRIOR TO FINAL DELIVERY. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 207 - ANCHORAGE OF SEATS AND 210 - SEAT BELT ASSEMB

THE COWL SCREEN FOR THE HEATER/AIR CONDITIONER BLOWER HOUSING MAY NOT PREVENT, IN SOME CASES, THE ENTRY OF SMALL LEAVES AND FOREIGN MATERIAL INTO THE BLOWER HOUSING. IF THIS MATERI

THE WALL OF THE FILLER HOSE, WHICH CONNECTS THE FUEL TANK TO A METAL TUBE, MAY HAVE BEEN PARTIALLY SLICED OR COMPLETELY CUT THROUGH DURING ASSEMBLY. THIS COULD RESULT IN FUEL LEAKA