Nissan Titan Recalls

On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash.

On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash.

On certain trucks, the transmission parking pawl may not engage when you shift to park. If this happens, the truck could roll away, if the parking brake isn't used.

On certain trucks, the transmission parking pawl may not engage when you shift to park. If this happens, the truck could roll away, if the parking brake isn't used.

Issue: Certain vehicles were built with tires that may have been cured too long. As a result, the sidewall could crack or the tread and belts could separate. This could lead to a s

On certain trucks equipped with a gasoline engine, the engine wiring harness (EGI) may not have been assembled correctly. As a result, an exposed wire could cause a short circuit.

Issue: On certain vehicles, the driver-front airbag inflator could be defective. This could cause the airbag to deploy with more force than normal. It could also cause the inflator

Issue: On certain vehicles, the rear view camera system does not return to the default setting when the transmission is shifted to reverse. This could cause a reduction in rear vis

On certain trucks, the alternator wiring harness may have been damaged during assembly. This could cause a short circuit to occur. It may result in abnormal electrical activity (i.

On certain vehicles, the brake master cylinder could malfunction, causing a reduction in braking performance which could increase stopping distances and potentially result in a cra

On certain King Cab vehicles, wires routed through the rear doors and into the body may break due to over bending as the door is opened and closed. The affected wires control seatb

Certain vehicles fail to conform to Canada Motor Vehicle Safety Standard 110 - Tire Selection and Rims. Specifically, the compliance label does not indicate the wheel rim size, as

On certain vehicles the Intelligent Power Distribution Module (IPDM) assembly contains an Engine Control Module (ECM) relay that has a diode for electrical current noise reduction.

On certain vehicles, the lower control link assembly collars (forming the inboard attachment point to the chassis) may not have been manufactured correctly. If the collar weld fail

On certain four-wheel drive vehicles, the joint portion of the front driveshaft may contain small cracks. These cracks may eventually lead to a failure, resulting in separation of

On certain vehicles, the brake pedal pivot pin end was not properly manufactured. As a result, the pin may not remain in place, causing the brake pedal to partially disengage from

On certain vehicles, the material used on fuel level sending unit contacts can wear and contaminate the sender. This causes the instrument panel fuel gauge to display that the vehi

Certain 2005-2006 model year vehicles may have been assembled with an incorrectly manufactured air conditioning condenser fan motor, which could allow excessive water intrusion and

Certain vehicles may have been assembled with faulty seat track assemblies. Specifically, the driver's inboard, and the passenger's outboard seat tracks, may have undersized slots

Certain vehicles fail to comply with CMVSS 110 - Tire Selection and Rims. The tire placard overstates the actual weight capacity. Loading a vehicle beyond it's capacity may result

On certain Crew Cab vehicles, there may not be sufficient webbing on the retractor spool for the rear center seatbelt to release from the automatic locking mode (ALR). To release t

Certain King Cab vehicles. Wires in the harness routed through the rear doors and into the body may break due to over bending of the harness as the door is opened and closed. On th

Certain King Cab vehicles fail to comply with the requirements of CMVSS 206 - Door Locks and Door Retention Components. The right side rear door upper latch assembly may not sustai

On certain vehicles, the shift lever assembly for the column shifter may have been damaged during installation. This could eventually result in failure of the portion of the assemb

Certain Titan King Cab and Crew Cab trucks do not meet the requirements of United States Federal Motor Vehicle Safety Standard 201 (seat belt anchorage on rearmost pillar). While C