Toyota Avalon Recalls

Issue: On certain vehicles, a sensor for the occupant classification system (OCS) may not have been manufactured properly. As a result, the sensor could short circuit and cause the

This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable

On certain vehicles, the low-pressure fuel pump could fail. If this happens, then engine may run rough or may not start and the check engine light may turn on. This could also resu

On certain vehicles, the low-pressure fuel pump could fail. If this happens, then engine may run rough or may not start and the check engine light may turn on. This could also resu

On certain vehicles, the circuits within the airbag control module could be damaged in a crash. This could cause the airbags and seat belt pretensioners to not deploy in certain cr

Issue: On certain vehicles, the low-pressure fuel pump could fail. If this happens, then engine may run rough or may not start and the check engine light may turn on. This could al

Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection in Frontal Impacts and CMVSS 214 - Side Impact Prote

On certain vehicles that had the driver’s and/or front passenger's seat belt buckle replaced, a switch within the replacement buckle may incorrectly signal that the seat belt is al

On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in

Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection in Frontal Impacts. The front passenger seat's occup

On certain vehicles equipped with Pre-Collision System (PCS), the system could unexpectedly activate while operating the vehicle. Under certain situations, the system may interpret

On certain vehicles equipped with a trunk-mounted sub-woofer, cargo in the trunk could contact the sub-woofer's soft braided wire, which could cause the wire to move out of its nor

On certain vehicles, a defect in the supplemental restraint system could result in an inadvertent deployment of the front airbag(s) and/or seatbelt pretensioner(s). Unintended seat

On certain vehicles, the end cap on the right-hand side fuel delivery pipe, located in the engine compartment, could have been improperly welded at time of manufacture. This could

On certain vehicles, a defect in the supplemental restraint system could result in an inadvertent deployment of the front airbag(s) and/or seatbelt pretensioner(s). Unintended seat

On certain vehicles, if the air conditioning condenser drain hose were to become clogged, water could accumulate and leak onto the airbag control module. This could cause the airba

On certain vehicles, the windshield wiper switch may have been manufactured incorrectly and could cause an electrical short when the wiper switch is moved from the OFF position to

On certain vehicles equipped with a 1MZ-FE or 3MZ-FE V6 engine, the crankshaft pulley may fail. The outer ring may become misaligned, or it may not properly rotate, causing noise a

Certain vehicles use brake fluids containing polymers that act as lubricants for certain brake system components. If during vehicle maintenance, brake fluid is used that does not c

On certain vehicles, a minute crack may develop on the surface of the steering lock bar, which is a component of the steering interlock system. Such a crack may expand over a perio

On certain vehicles, accelerator pedal movement may become rough, slow to return, or the pedal may stick in a depressed position. This could result in a loss of throttle control an

On certain vehicles, the accelerator pedal may become stuck in the wide open position due to an unsecured or incompatible driver's floor mat. A stuck open accelerator pedal may res

On certain vehicles, the steering yoke may not have been welded to the steering shaft during assembly. Separation of the yoke and the steering shaft would result in a loss of steer

On certain vehicles, improper heat treatment during assembly could result in inadequate strength in certain areas of the rear axle shafts. After extended use of the vehicle, the re

UNDER EXTREMELY LOW TEMPERATURE OPERATING CONDITIONS AND INFREQUENT BRAKE OPERATION THERE IS THE POSSIBILITY THAT CONDENSED MOISTURE FROM A SURGE TANK MIGHT SEEP INTO THE BRAKE BOO