Toyota Celica Recalls

This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable

On certain vehicles, exposure to moisture over time could cause the driver-front airbag not to inflate properly in a crash. In some cases, this could cause an airbag not to fully i

On certain vehicles, the recess that retains the rubber seal ring, which is located at the end of the brake master cylinder body, may be corroded due to an improper washing process

On certain vehicles, the check valve inside the fuel filler pipe may fall into the tank during refueling. This condition could cause fuel to spill out of the fuel filler pipe when

On certain Panasonic Edition vehicles, the driver's floor mat may slide along the interior floor carpet when pressure is applied to the mat by getting in or out of the vehicle. As

ON VEHICLES EQUIPPED WITH CRUISE CONTROL, THE CRUISE CONTROL COMPUTER CIRCUIT BOARD MAY DEVELOP A FAULT THAT MAY RESULT IN HIGH ENGINE SPEED WHEN THE ENGINE IS STARTED WITH THE MAI

1980 CELICA, CORONA AND PICKUP TRUCKS. IN INCOMPLETE EMISSION CONTROL LABEL MAY CAUSE THE IGNITION TIMING TO BE MISADJUSTED. THUS VEHICLES DO NOT COMPLOY WITH CMVSS 1101 - EMISSION

THE ENGINE ALTERNATOR PULLEY MAY BREAK WHILE THE ENGINE IS OPERATING. THIS CONDITION COULD RESULT IN DAMAGE TO UNDERHOOD COMPONENTS OR INJURY TO SERVICE PERSONNEL.

POSSIBILITY THAT THE MOULDED HEATER INLET HOSE LOCATED UNDER THE INSTRUMENT PANEL MAY HAVE BEEN DAMAGED DURING INSTALLATION. VEHICLE OCCUPANTS COULD BE SPRAYED BY HOT ENGINE COOLAN