Toyota Highlander Hybrid Recalls

Issue: On certain vehicles, the seatback recliners for the second-row seats may not have been manufactured properly. As a result, the seatback(s) may not lock in position and could

On a small number of vehicles, the bolt that secures the third-row center seat belt anchor to the roof may not have been installed properly. As a result, the seat belt could loosen

On certain vehicles, the steering wheel spiral cable assembly could disconnect. If this happens, the airbag (SRS) warning lamp would turn on, and the driver-front airbag wouldn't w

Issue: On certain vehicles, a sensor for the occupant classification system (OCS) may not have been manufactured properly. As a result, the sensor could short circuit and cause the

On certain vehicles, the front lower bumper cover may not be attached properly. As a result, if there is a minor impact to the front bumper, the lower bumper cover, engine under co

This recall was replaced by Transport Canada recall no. 2025-242. Issue: On certain vehicles, the steering wheel spiral cable assembly could disconnect. If this happens, the airbag

Under certain conditions, the vehicle stability control (VSC) system may not switch on when the ignition is restarted. This can happen if the driver manually turns off the VSC, dep

This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable

On certain vehicles, one or both of the front seats may have an incorrect trim cover installed. This could prevent the front seat-mounted side airbags from inflating properly in a

On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in

On certain vehicles, inconsistent application of grease during the manufacturing process could cause the driver's side power window master switch to stick or become inoperative due

On certain vehicles, the circuit board for the electric power steering electronic control unit may be damaged. A damaged circuit board could result in sudden loss of steering power

Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection. A defect in the programming of the occupant classif

On certain vehicles, a control board for the Intelligent Power Module (IPM), part of the hybrid system inverter assembly, could fail while the vehicle is underway. This could cause

On certain vehicles, due to improperly applied grease, the driver's side power window master switch could stick or become inoperative. If attempts are made to lubricate the switch,

On certain vehicles equipped with a 1MZ-FE or 3MZ-FE V6 engine, the crankshaft pulley may fail. The outer ring may become misaligned, or it may not properly rotate, causing noise a

On certain vehicles, a control board for the Intelligent Power Module (IPM), part of the hybrid system inverter assembly, could fail while the vehicle is underway. This could cause

On certain vehicles, the roll angle sensors in the airbag sensor assembly could fail. If one of the roll angle sensors malfunctions, the airbag warning lamp will illuminate, the ro

On certain vehicles, if the forward retention clip used to secure the floor carpet cover, which is located in front of the center console, is not installed properly, the cover may

On certain vehicles, if the Toyota optional accessory "tray-type" floor mat is not secured by the retaining hooks, or if it is placed on top of an existing floor mat, the "tray-typ

On certain vehicles, due to the improper installation of the retaining clips for the floor carpet cover located in front of the center console, there is a possibility that the clip