Volvo S80 Recalls

Issue: On certain vehicles, the flexible steel cable that attaches the seat belt to the outside of the front seats may weaken over time. As a result, the seat belt could detach. Sa

On certain vehicles with an automatic stop-start function, in certain stop and go driving situations, the starter motor fuse may become overloaded (blown fuse). This could lead to

On certain vehicles equipped with Keyless Ignition, the Central Electronic Module (CEM) may not perform as intended. When starting the engine, the amber coloured warning light in t

On certain vehicles, when driving, an error in the automatic transmission control system could cause the engine to stall. Engine stalling would result in lost vehicle propulsion wh

On certain vehicles, the wire harness under the driver and/or passenger seat may not have been properly affixed to the seat frame during vehicle assembly. As such, the harness may

On certain vehicles, the power steering reservoir return hose may have been incorrectly routed (pinched or kinked) during vehicle assembly. This could increase pressure in the powe

On certain vehicles, the engine and transmission software calibration is too sensitive. When the driver brakes during city driving, and/or releases the accelerator pedal, the engin

On certain vehicles, there is a possibility of overheating issues of batteries in the Garmin nüvi® 760 when certain batteries manufactured within a limited date code range are used

On certain vehicles, there may be an intermittent fault in the driver's airbag clockspring wiring connector for the Supplemental Restraint System (SRS). If this condition occurs, t

On certain vehicles, the software within the Central Electronic Module (CEM) may not send a signal to the fuel Pump Electronic Module (PEM). This missing signal to the PEM inhibits

On certain vehicles, the engine cooling fan may stop working due to a software programming error in the Fan Control Module (FCM). Depending on conditions, the driver may experience

On certain vehicles, the diagnostic software in the Central Electronic Module (CEM) may cause a malfunction of the windshield wiper functionality. If this occurs, the windshield wi

Certain vehicles may have been inadvertently assembled with incorrect engine mount bolts. The longer bolts do not provide adequate clamping force to the bracket. In the worst case,

On certain vehicles, a combination of throttle position sensor (TPS) irregularities, a dirty throttle housing, and/or inefficient software calibration, may cause a warning lamp to

Certain vehicles fail to comply with the requirements of CMVSS 110. The Tire and Loading Information Label contains incorrect tire inflation pressure value. If the vehicle is equip

On certain vehicles, the positive battery cable may wear against the starter solenoid. The resulting chafe damage could develop into an electrical short. This can be noticed in dif

On certain vehicles, the electric cooling fan may overheat, potentially causing heat damage and, in rare instances, a fire in the engine compartment. Correction: Dealers will repla

On certain vehicles, the front lower control arms may not have been manufactured within the agreed specifications and as a result the stud and nut that secure the control arm to th

Certain vehicles do not comply with CMVSS 210.2. The symbol indicating the presence of a lower universal anchorage system, and a reproduction of this symbol were omitted from the o

On certain vehicles the electric cooling fan can overheat in a hot climate. Correction: Dealers will replace the cooling fan with a modified design.

On certain vehicles, the rear outboard seat belt anchorage bolts may have been incorrectly tightened. Correction: Vehicles will be inspected and, if necessary, anchorage bolts will

On certain vehicles, the ball joint, between the front wheel king pin and the suspension link arm, may experience increased play which could affect durability and performance. This