Volvo Vt Recalls

On certain vehicles, the secondary clutch disengagement switch may have been omitted during vehicle assembly or, in some instances, removed during servicing. As such, primary switc

On certain trucks equipped with an air release fifth wheel hitch, the inversion valve on the frame may be orientated where contaminants can enter the valve through the exhaust port

On certain vehicles, the tire description may be incorrect on the certification label, which is a non-compliance to Canada Motor Vehicle Safety Standard 120 - Tire Selection and Ri

On certain vehicles, the windshield wiper motor may be susceptible to water intrusion, which could result in an electrical short circuit and a fire. This could cause property damag

On certain trucks, incorrect software installed during vehicle assembly will cause the Diesel Particulate Filter (DPF) inhibit function to be disabled. As such, the driver may not

On certain trucks, the automatic circuit breakers used to protect the vehicle lighting system may not provide adequate protection. If a short circuit occurs, components and wiring

On certain trucks, the bolts that attach the steering gear to the frame may not have been tightened to the specified torque. This could allow the bolts to loosen and fall-out, poss

On certain trucks, the fifth wheel hitch assembly's lever arm may have been incorrectly installed during the manufacturing process. The lever arm pivot bolt may have been over-tigh

On certain vehicles, inadequate hood cylinder dampening may allow the hood to be opened with too much force. Once the cylinders reach full extension, this lack of dampening could c

On certain trucks, when the ignition key is in the 'ON' position, the pre-heater, located in the fuel filter base, is energized. If this pre-heater is energized while maintenance i

On certain trucks, the locknut used to retain the steering shaft may not have had the lock feature. As a result, the nut could loosen, allowing the steering shaft to separate, caus

On certain trucks, an improperly seated or missing u-joint snap ring can result in the bearing cup to separate from the slip yoke sub-assembly. The u-joint could then contact the s

On certain vehicles, the steering shaft pinch bolt hole may be incorrectly located. As a result, the steering shaft may separate from the steering gear which could lead to a sudden

On certain vehicles, the rear suspension transverse beam castings were not made to specifications. If a casting were to break when the vehicle is in motion, parts could become proj