Altec An Series Recalls

On certain aerial devices and digger derricks, the cable step wire ropes that secure the entry step could fail. As a result, the cable could detach and cause a person to fall.

On a small number of aerial devices, the cap at the end of the hydraulic lift cylinder could detach. If this happens, the boom lift can drop suddenly.

On certain aerial devices and digger derricks, the inverter module may not have proper circuit protection for the AC output. As a result, the wiring could overheat and melt.

Issue: On one AN67-E100 aerial device, the upper and lower boom lift cylinder hoses may be plumbed incorrectly. As a result, the boom may be extended too far and the unit could tip

Issue: On certain aerial devices, the platform leveling sprocket may not have been properly welded and could fail. If this happens, the platform may not stay level and could tip su

On certain aerial devices and digger derricks, a snap ring in the hydraulic check valve assembly could fail. If this happens, the snap ring can get stuck in the hydraulic system. T

On certain aerial devices, the cylinder end gland could fail which could cause uncontrolled boom movement which would increase the risk of injury to the operator. Correction : Deal

On certain aerial devices and digger derricks, the upstream 30A breaker to the trailer relay module may react too slowly to prevent the module from overheating, which could cause a

Certain aerial devices and digger derricks, installed on utility service vehicles (to elevate personnel in order to facilitate working on overhead service lines, for tree trimming,