Polaris Slingshot Recalls

On certain vehicles, a software problem could cause the rearview camera image to freeze when the transmission is shifted out of reverse. If this happens, the rearview image may not

This recall is for certain accessory heated and cooled seat kits sold with new vehicles or sold by parts departments at Polaris dealerships. The seat kit has part number: 2884701-V

Issue: On certain vehicles, the wheel studs on the rear axle may not have been assembled correctly. As a result, the rear wheel nuts could loosen over time. If this happens, the wh

On certain vehicles, a problem with a 10-A circuit breaker could result in intermittent electrical issues. This could result in a loss of power to the engine or the lights.

On certain vehicles, the terminals of the battery fuse block could be damaged during normal driving. This can result in a loss of forward and rear lighting, a loss of gauges, and a

On certain vehicles, the seat base may have been assembled improperly. This could cause the seat belt buckle to detach or cause the seat slider not to latch properly. This could re

On certain vehicles, the rearview camera could fail internally and overheat, creating a fire risk. This could also result in loss of tail light function. Both of these conditions c

On certain vehicles, a problem with the seat belts could cause them not to stay tight during a side crash. Specifically, the seat belt retractor on the opposite side of the impact

Certain vehicles may fail to conform to the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 111 – Mirrors and Rear Visibility Systems. The rear view image can be tempo

On certain vehicles, the pin and retaining clip that join the brake pedal to the master cylinder may have been installed incorrectly. This could allow the separation of the brake p

On certain vehicles, the seat belt buckle and seat back may dislodge from seat base and/or the seat sliders may not latch properly. If the seat were to slide unexpectedly, vehicle

On certain vehicles which had a rear swing arm previously replaced under recall T-16-06 (Transport Canada no. 2016-520), the swing arm may have been installed without two dust plug

Certain vehicles may not comply with Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection in Frontal Impacts. The vehicle fails to provide an audible warning if t

Certain three-wheeled vehicles may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 202 - Head Restraints. The vehicles imported from the U.S. to be sold in Canada a

On certain vehicles, due to a defect in manufacturing, the rear swing arm may not meet strength specifications. This could result in the potential for the swing arm to fracture if

On certain vehicles, the brake pressure switch may have been over torqued during manufacturing. After a period of non-use, this could cause the brake seal to leak, resulting in inc

On certain vehicles, there may be insufficient clearance between the fuel line and hood structure. This can result in abrasion of the fuel line, which could result in a potential f

On certain vehicles, the electrical relay used for the headlight circuit could cause the headlights to operate intermittently or turn off while the vehicle is in operation. This co

On certain vehicles, the steering rack may have been manufactured with a defective bearing. This could affect steering system function, or result in a loss of steering control, whi

On certain vehicles, some roll hoops do not meet the manufacturer's hardness specifications and may not provide the level of protection that was originally intended. In the event o