Autocar Wx Recalls

Certain vehicles may develop cracks in the top flange of the front frame rail extension. Over time, the crack may propagate across the extension bracket, potentially causing the ex

On certain vehicles, a leak in one or both Quick Release Valves (QRV) could occur. The first QRV is located in the lift axle air lines. A leak in that QRV would affect the rate at

On certain vehicles, the lower steering shaft pinch bolt may not have received adequate tightening torque during vehicle assembly. As a result, the steering shaft may separate from

On certain trucks, the certification label does not contain the correct Gross Vehicle Weight Rating (GVWR). The label may indicate that the vehicle's load capacity is higher than t

On certain vehicles, the internal rubber check valve inside the Bendix SR-7 spring brake modulating valve can become deformed over time. The effect of this defect is intermittent a

On certain trucks, fasteners that fix the steering column brackets may not have received adequate tightening torque during vehicle assembly. Over time, the fasteners may loosen cau

On certain vehicles, the fasteners that secure the seat base to the cab floor bracket may have been left loose or omitted during vehicle assembly. Improperly torqued seat-mounting

On certain vehicles, the steering shaft pinch bolt could loosen and slide out partially, limiting the rotation of the steering shaft. Restricted steering control could result in a

On certain vehicles, the rear suspension transverse beam castings were not made to specifications. If a casting were to break when the vehicle is in motion, parts could become proj

On certain vehicles, testing procedures designed to verify that the ABS brakes are wired correctly and that all hardware is operational were not performed properly during vehicle a

On certain vehicles, the air suspension height control valve may not be plumbed through an air pressure protection valve. In the event of a suspension air bag failure or rupture of

On certain vehicles, the ABS sensor bracket may not have been installed correctly on the front axle and may interfere with the brake hose return spring causing the brakes not to re